© Copyright 2018, Creative Playthings
BRIDGEHAMPTON PREMIUM PACK 2
BRID9WPP2-100 Rev A (12-19)
Page 2
• Skybox Step 17. Wait to install the wall slats on the back
and side where the bubble panel and slides will mount,
and the side where the Swoosh Slide will mount until after
installing the bubble and slide.
• Skybox Step 21 & 22. Install the slats in reverse orientation
so the opening is on the opposite side. Install the ladder
aligned with the opening.
• Ignore the special instructions regarding mounting with
play floors in the Skybox instructions. Use the method
found on the bottom of page three of the skybox play floor
instructions.
• Once the basic Williamsburg-Skybox tower is assembled
assemble the Lexington tower about 92" away from the
Williamsburg. Please note: The swing beam extends from
the end of the tower, 90° from the position shown in the
beam assembly instructions.
• Wait to install the Access Ladder, Slide, and Wall Slats until
after the whole play set is complete.
• Lex step 7. Do not install the safety rail. It will be used for
the picnic table.
• Lex step 8. Before securing the angle braces, move the
tower into place 92" from the other tower. Use the bridge
rails from SJ951-102 to assure the alignment is exact.
Continue assembly making sure the posts are plumb and
the towers are level.
• Lex step 15. No swing mount is needed.
• Lex step 25. Before installing the roof, find the post where
the swing beam will mount. Drill 7/16" diameter holes
through the post at 3", 7-1/4" and 15-1/2" below the top of
the post as shown at above right. The beam will be mount-
ed to the front of the post using these holes. Insert one
5/16" weld nut into the top hole on the inside face of the
post. Be sure the threads on the weld
nut are clear, it will be captured by the
roof support. Install the roof.
• After installing the roof, install the
bridge between the towers using the
instructions from SJ951-102.
• Install the swing beam. Instructions
and hardware are in the 9' Swing Beam
Leg Carton (63060-222).
• Install the Monkey Bars (63079-102) to
the front center of the Bridge.
• Using a ladder, install three Dormers
(SM963-402) in the positions shown on
the front page. Ladder access may be
obstructed by later installations.
• Install 3 pairs of Gable Fans (SM964-
402) at each end of each roof.
• Install the Wmsburg Play Floor (SC908-
800Q) and Skybox Play Floor (SC904-800Q) using the
method shown on page 3 of the Skybox Play Floor Manual.
• Install the Lexington Play Floor (SC910-800Q).
• Install the Lexington Picnic Table (SD204-102Q).
• Mount the Window and Door Panels (40456-402, 40457-
402, & 40458-402) in the Williamsburg tower as shown
above.
• Mount the Rock Climbing Wall (AH201-102Q) in the posi-
tion shown.
• Mount the Cargo Climber (63090-222) to the center of the
back of the Lexington tower.
• Mount the Super Wave Slide (15166-400), Access Ladder
(SH946-102) and Ramp (SH922-800Q) across the front of
15 1/2"
7 1/4"
3"
0"
