Assembly
PINE ROCK CLIMBER
19581-700 Rev E (01-18)
© Copyright 2004, Creative Playthings,
Page 3
ASSEMBLY INSTRUCTIONS
STEP 3 — Attach Brackets to Rock Climber:
Attach the Access Ladder Brackets to the Angled Rails of the
Rock Climber Assembly using the holes provided. Use One
5/16 x 1-1/2" Hex Bolt, one Lock Washer, one Flat Washer,
and one Weld Nut to fasten each Access Ladder Bracket.
Note: The Access Ladder Bracket can be mounted to the
inside or outside of the Angled Rails.
STEP 4 — Attach Rock Climber to Playset:
Lean the Rock Climber Assembly into place against the
Platform Support in the position desired. Position the Access
Ladder Brackets with one surface flat against the surface of
the Platform Support. Mark the position of the holes in the
Brackets onto the Platform Support.
If the Access Ladder Bracket is to be fastened to the Platform
Support only, drill a hole at the mark using a 3/8" diameter
drill bit. Any Wall Slats that may interfere should be removed.
Fasten each Access Ladder Bracket to the Platform Support
using one 5/16" x 1-1/2" Hex Bolt , one Lock Washer, one
Flat Washer, and one Weld Nut.
If the Wall Support is backed by a Corner Post or any other
solid structure, drill a 1/4" diameter hole 2" deep. Fasten with
a 5/16 x 2-1/2" Lag Screw and Flat Washer.
Note: In it's final position the base of the Rock Climber
should be set into the ground to the level of the large
hole in the Rope Board.
STEP 5 — Fasten Top Rock Board:
Use two 1/4 x 4" Hex Bolts, two 1/4" Lock Washers, two 8mm
Flat Washers to fasten the Top Rock Board (E) to the Angled
Rails (A). Thread the Bolts through the Angled Rails and Top
Rock Board then into the Weld Nuts inserted in step 1.
Finish securing the Top Rope Board using four #10 x 2-1/2"
T25 Screws.
Drill a 1/8" diameter pilot hole for each Screw.
