Space Saver Beam Instructions - 19939-100C (08/17)
Copyright 2016, Creative Playthings - Printed in U.S.A.
Page 7
STEP EIGHT - Nameplate
STEP NINE - Ground Stakes
STEP TEN - Restore Parts
Federal law requires the name of the manufacturer be per-
manently fastened to the gym, for identification in case of
recall or warranty claim. The Space Saver Beam includes
a nameplate. It is important to fasten the nameplate to the
gym.
Place the nameplate at the center of the Beam. Use the in-
cluded #6 x 1/2" pan head screws to attach the nameplate.
Leave the screws slightly loose to keep the nameplate from
bending as the wood swells and shrinks with changes in hu-
midity.
Drive each Ground Stake (H) into the ground next to a Base
Extension, as shown. Secure the Stakes directly into the
Bade Extension using two #10 x 2-1/2" Screws each.
The top of the Stakes must not extend beyond the top of the
Base Extension.
Note: Do NOT use concrete to set Ground Stakes. Pound a
metal spike or rod into the ground to start a hole in hard or
rocky ground.
Restore any Wall Slats or other items removed in Step One
that will not conflict with the safe zone in front of and behind
the swings.
Fill any open spaces using Wall Slats removed in Step One.
Evenly space the Wall Slats and fasten them using the
screws from Step One.
Evenly space Wall Slats to fill any openings in the side walls
of the tower. Make sure all gaps formed by Wall Slats are less
than 3-1/2". Secure the Wall Slats using #8 x 1-5/8" Screws.
WARNING: To avoid serious injury or death, the space
between Wall Slats or any other members MUST be less
than 3-1/2" or greater than 9".
Avoid creating gaps less
than 1/2"; the gaps may cause finger entrapment.
H
