www.cls-led.com
www.cls-led.com
- 8 -
- 1 -
CLS Manuals
CLS RGB LED Par Controller
Version 1.1 October 2009
CLS RGB LED Par Controller
2007 CLS-LED BV. All rights reserved. Information subject to change without notice, CLS-LED BV and all affiliated companies disclaim liability for injury, damage
direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to use or reliance on the information contained in this
manual. No part of this manual may be reproduced, in any form or by any means, without permission in writing from CLS-LED BV. Other legal information can
be found in our General conditions to be found on the back of your CLS-LED BV invoice or on our website www.cls-led.com/Conditions.pdf
2 At any time, you can adjust the Strobe flash rate by pressing and holding down the "Strobe" button and
then manually adjust the Speed fader.
3 Press the "Strobe" button again to disengage the strobe effect.
Factory DeFault reset
1 Switch the LeD controller main power oFF.
2 Press and hold down Colour Preset buttons 1, 6 & 8 then
simultaneously switch the power switch oN then release all
buttons. All LeD indicators will flash three times to confirm that
factory settings have been restored.
technical speciFications
Power Input:
9 VDC
Power consumption: 5 Watt
connection:
3P XLr connector
DMX output:
DMX512
Dimension:
60 x 245 x 178 mm (hxwxd)
Housing:
Steel
Weigth:
1,60 kg
Attention:
tHiS oPeRAtion WiLL eRASe ALL USeR-CReAteD CoLoUR
PReSetS AnD CHASeS.
W
ARNING
1,60 kg
