Robot Buggy – Build Instructions
Page
4
of
5
Step 5:
Use the cable tie, through the middle square holes at the wider end of
the chassis, to attach the edge connector to the chassis.
Step 6:
Plug the jumper leads into the edge connector in the following
configuration:
Pin 13
Pin 14
Pin 15
Pin 16
Green
Yellow
Blue
Burgundy
E. Final Touches
Step 1:
Cut off the loose end of cable tie, and tape down the jumper wires and
battery pack wires so they cannot catch on anything.
Step 2:
Follow the buggy leaflet’s instructions to attach the front castor wheel
– this can be fiddly, so don’t fully tighten the screws until they are all
in place.
Step 3:
Carefully push the wheels onto the motors.
Step 4:
Using the mu editor, flash the TEST.py program to your micro:bit.
CHECK:
Does your micro:bit show a smiley face? If not, flash again.
Step 5:
Unplug your micro:bit from the computer, and attach the battery pack.
Step 6:
Slot your micro:bit into the edge connector.
Summary of Contents for Robot Buggy
Page 6: ......
