Robot Buggy – Build Instructions
Page
2
of
5
A. Preparation
Step 1:
Peel paper backing from robot chassis.
Step 2:
Take out the instructions from the buggy pack and scan through the
pictures, so you know which part attaches where.
B. Soldering
Step 1:
Solder the spare wires to the motors.
Step 2:
Push the switch into the chassis, so that the ‘0’ side is facing the
narrower end of the chassis, and the ‘1’ side is facing the wider end.
Step 3:
Follow the buggy leaflet’s instructions to screw the battery pack onto
the chassis. Feed the wires through one of the holes, so they are near
to the bare ends of the switch.
OPTIONAL: Cut both battery pack wires to a shorter length.
Step 4:
Solder the red battery pack wire to the switch, to the leg that is in the
middle of the plastic.
Step 5:
Solder the red half-jumper lead to the other leg of the switch.
Step 6:
Solder the black half-jumper lead to the black battery pack wire.
OPTIONAL: Use electrical tape or duct tape to cover the join in the black wire.
Summary of Contents for Robot Buggy
Page 6: ......
