Create WIND ROUND, User Manual

Page: 9 / 64

9 ENGLISH
ASEMBLING AND HANGING THE FAN
Electrical wiring
Canopy
Hanging ball slot
Decorative cover
Bolt
Cotter pin
Adapter
Fixing screw
Cotter pin
• If you wish to extend the hanging length of your fan, you must remove the hanging ball
from the downrod provided to use with an extended downrod (included).
(If you wish to use the downrod, please proceed to instructions below.)
• To remove the hanging ball, loose the set screw on the hanging ball and remove the pin
and bolt. Lower hanging ball and remove stop pin. Slide hanging ball off the original
downrod, and slide it down the longer downrod (the top of the downrod should be noted
as having a fixing screw hole; use this hole when setting the fixing screw).
• Insert stop pin into top of extended downrod and raise hanging ball.
• Be sure that the stop pin aligns with the slots on the inside of the hanging ball, tighten
the fixing screw securely.
Tip : To prepare for threading electrical wires through the downrod, apply a small piece of
electrical tape to the ends of the electrical wires. This will keep the wires together when
threading them through the downrod.
•
Loosen the fixing screws and nut at the top of the motor housing. Remove the pin and
bolt from the downrod (if you have not already done so). Slide the downrod through the
canopy.
• Tread electrical wires through the downrod and pull extra wire slack from the upper end
of the downrod.
• Place the downrod into the motor housing yoke and reinsert the pin and bolt that were
previously removed. Tighten the fixing screws and nut securely.
• Lower the canopy to the motor housing.