Create WIND CALM PATIO, User Manual

Page: 9 / 48

9 ENGLISH
CHECK INSTALLATION
LED PANEL INSTALLATION
Single pin plug
LED panel
Connect the single pin plugs on the breakout board to those on the LED panel. The LED panel
is magnetized so it attaches to the backplane by simply snapping the two pieces together.
Note : While installing or removing the LED board, be careful not to touch the insulating tabs.
Do not overtighten or fasten the screws as this may cause damage to the insulating tabs.
Put the decorative screen on the LED plate.
• Check the correct operation of the ceiling fan, checking that there is no strange movement
or misalignment in any part of the fan.
• In the event that some type of buzzing/vibration can be seen, you can proceed to adjust the
blades with the balancing kit.
• In this kit you have self-adhesive weights and "u" clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip on
another blade or use the adhesive weights.
CONNECTION PANEL MOUNTING
Attach the plate to the bottom of the fan by inserting the screw heads into the designated
screw holes. Thread the screws and then secure them.
Patch panel
Panel screws