546Wd_547Wd_548Wd_550Wd— Rev. 10/09 — Page 3
546Wd 547Wd, 548Wd & 550Wd
Extension Table Top
ASSEMBLY INSTRUCTIONS
1.
Lay the Table Top and the Leaves (Ac) face down on a clean, protected surface. Make sure the
arrows stamped on the table ends and leaves face each other. Pull sections slightly apart and glue
Guide Pins (N) into the predrilled holes. Make sure all of the pins face the same direction. See
Figures 1 and 1a.
2.
Starting from one end of the table, place
the Lever Locks (K) over the pre-punched screw holes.
All the lever locks must face in the same direction on both sides of the table. Fasten the lever locks
in place with #8 x 5/8" Flat Head Screws (Ld). Slide the Leveler Plate (M) into the lever locks and
fasten with #8 x 5/8" Flat Head Screws (Ld) in the predrilled holes. See Figures 1a and 1b.
3.
The leaves and leaf aprons have been marked with matching letters (
AA/AA; DD/DD
) to help you
position the Leaf Aprons in their proper locations. The leaves have been predrilled to help attach the
aprons. Insert a #8 x 1¼" Pan Head Screw (H) through three holes in the Leaf Apron (Fc) into
the predrilled holes in the Leaf (Ac) and fasten securely. To increase support for the leaf aprons,
fasten a Brass Angle Brace (I) just to the left or right of the center hole of the aprons with #10 x ¾"
Brass Oval Head Screws (J). See Figure 2.
Ac
H
Fc
J
I
Ac
Ac
Ac
Ac
K
M
Ld
N
K
Ld
Ac
Ac
N
H
H
AA
AA
Fig. 1
Fig. 1a
Fig. 2
Fig. 1b
GLUE ALL
PINS IN
THIS STEP
The lever locks are located outside of the
aprons on the 546Wd & 550Wd.
