8
u
Automatic leveling
7. Bed Leveling pt. 2
1. In “Settings” → “Leveling mode” → Place the .2mm feeler gauge between the nozzle and the hot bed → If the gap is too thin
or too large, click "Z+" or "Z-" on the interface to adjust the gap to slightly more than 0.2 mm(the distance between the nozzle
and the hot bed should be about 0.25 mm). At 0.2 mm the feeler can easily pass through the gap between the nozzle and the
printing platform.
2. To adjust position of the auto-level sensor, turn the sensor
clockwise to lower it and counter-clockwise to raise it.
3. If the LED is lit, raise the auto-level sensor by turning it
counter clockwise.
4. The slowly turn the sensor clockwise until you see the LED
light up again.
Restore hotend to original
home position
Auto-level the printing surface
16 point precise bed height
measurement
Printer will automatically
compensate for variable bed height
*When using the auto level feature on the CR-10S Pro, we suggest
adding a raft from the build plate adhesion section in Cura's settings.
