03
Connect the aviation connectors to the
ports with corresponding pins
Y Stepper and Limit Switch
Extruder (E) Stepper
X Stepper and Limit Switch
Z Stepper and Limit Switch
Connect the Stepper Motors according to
the yellow labels on the 6pin (4- wire) side.
Connect the Limit Switches according to the
yellow labels on the 3pin (2- wire) side.
•
Select the correct input voltage to match your local
mains (230V or 115V)
•
Damage can occur if voltage is set incorrectly.
•
Make sure the power cable is connected.
3.Introduction
Summary of Contents for CR- 10
Page 1: ...3D Printer User Manual V 6 6 CREATE REALITY ACHIEVE DREAMS CR 10 S5 CR 10 S5...
Page 2: ......
Page 22: ......
Page 23: ......
