BIO
REMEDIATING parts washing system
SmartWasher
®
USER INSTRUCTION MANUAL
ORIGINAL INSTRUCTIONS
page 27 of 80
9. Operation
9.1. Start Up
●
Unpack the SmartWasher
®
;
●
Install the equipment as described in par. 7.1 of this
user instruction
●
Take away the basket and the OzzyMat
®
;
●
Depending on the model, carefully add ± 60 or ± 95
liter of OzzyJuice
®
to the SmartWasher
®
, by slowly
pouring the solution directly into the sink;
●
Plug in the SmartWasher
®
to the main power supple
(220 VAC);
●
The “Add Fluid” sign should be out when enough
OzzyJuice
®
has been added
●
Please note that the heater will not operate if the
“Add Fluid” sign is illuminated.
●
Your SmartWasher
®
should be plugged in 24 hours
a day,7 days a week in order to maintain the optimal
temperature;
●
Depending on the OzzyJuice
®
solution shipped with
your SmartWasher
®
, the thermostat is factory-set
to maintain a fluid temperature between 40°C and
46°C (± 1°C). This temperature provides the opti-
mum condition for effective cleaning and activity of
Ozzy microbes.
- If, after a reasonable warm-up period, the fluid
temperature seems too high or too low, please
refer to the troubleshooting part in chapter 11
of this instruction manual.
- The SmartWasher
®
uses a specially formulated
fluid, called OzzyJuice
®
. This is a degreasing solu-
tion which provides a combination of excellent
cleaning characteristics, safety and nutrition for
the Ozzymicrobes. OzzyJuice
®
is provided in
ready-to-use containers of 20 litres.
- If the temperature falls below the recommend-
ed minimum temperature, the system will still
clean, but remediation of the hydrocarbons by the
Ozzy microbe colony will slow down. However,
the microbes will not die. The Ozzy colony will
become more active when the fluid temperature
reaches the appropriate above mentioned tem-
perature range.
9.2. Operation
●
The heater will not operate when the fluid level
becomes critically low. Lift the sink and check the
fluid level.
●
To help monitor and maintain the proper fluid level,
the SmartWasher
®
is equipped with an “Add Fluid”
light. When the “Add Fluid” sign illuminates on the
heater, the unit (including the heater) will automat-
ically switch off until OzzyJuice
®
has been added.
●
Adding OzzyJuice
®
: Take away the false bottom with
the OzzyMat
®
, and slowly pour a full container (of 20
litres) directly into the SmartWasher
®
sink. The “Add
Fluid” sign should go out when you have completed
the process.
●
The “Add Fluid” sign will shut off and the heater will
automatically switch on again.
●
Place the parts to be cleaned on the rinsing floor
of the equipment. The maximum load capacity is