Crathco PIC-1-DC, Operation And Instruction Manual

Page: 8 / 26

Weekly Cleaning
Removing and Cleaning the Chambers
(Refer to Figure D)
1. Open the door and remove the mixing funnel shroud by pulling forward while turning 1/4 turn to the right.
Lift off and remove.
2. Remove the mixing funnel by lifting the neck of the funnel out of the whipper chamber, then tilt to the left.
With one hand on the water inlet fitting on the back panel, pull the funnel out of the white ring.
3. Remove the whipper chamber by rotating it 1/8 of a turn to the right, then pull to remove.
4. Remove the whipper blade by grasping the whipper blade with two fingers and firmly pulling to remove.
5. All parts in contact with food must be washed, rinsed, sanitized and air dried.
To Reassemble
1. Replace the whipper blade by aligning the flat side inside the blade with the flat side of the motor shaft.
Push blade firmly onto shaft.
2. Replace the whipper chamber by positioning the medium sized opening up and tilting 1/8 of a turn to the right.
Put the whipper chamber over the whipper blade and turn to the left until it locks into place.
3. Replace the mixing funnel by positioning the large opening up and tilting it slightly to the left. Lubricate the
o-ring on the water inlet pipe with a film of food grade grease. Insert the water inlet pipe into the water inlet
fitting on the back panel, then rotate the funnel to the right until the neck of the funnel seats inside the
whipper chamber opening.
4. Replace the shroud by placing it on the mixing funnel with the opening to the right. Turn the shroud to the
left until the opening in the shroud rests inside the opening in the back panel.
Note: Whipper seals should be replaced every (6) months to prevent wear.
Disassembling & Cleaning the Hoppers
1. Open the door and rotate the dispense elbow on the
hopper to the "UP" position to prevent spillage.
(Figure E)
2. Remove the hopper from the cabinet.
3. Remove the hopper cover and empty hopper
contents.
4. Pull off the elbow.
5. Remove the auger pinwheel by pulling it forward while
stretching out the sides of the hopper. (Figure F)
6. Remove the drivelink and washer at the rear of the
hopper by holding the auger spring with one hand at
the front of the hopper while turning the drivelink
clockwise with the other hand. (Figure G)
7. Remove the auger spring and auger spring
driveshaft by pulling them out through the lower
front opening of the hopper. (Figure H)
8. Remove the palnut at the rear of the hopper by
turning it counterclockwise, then remove the
driveshaft bearing from the inside of the hopper.
9. All parts in contact with food must be washed, rinsed,
sanitized, and air dried.
Crathco Powdered Beverage Dispensers Page 8
CAUTION! Do not wash hopper without first disassembling.
!
Figure H