C R A T E
8
YPP117
DUAL MONO 1/4" TO
STEREO 1/4" ADAPTER
STEREO 1/4" TO
STEREO 1/4" CABLE
TO
INSERT
JACK
TO
STANDARD
INSERT
JACK OF
EFFECT
(IF EFFECT IS NON-INVER
TING)
TO
INVERTED
INSERT
JACK OF
EFFECT
TO
MONO
OUTPUT
JACK OF
EFFECT
TO
MONO
INPUT
JACK OF
EFFECT
TO
MONO
OUTPUT
JACK OF
EFFECT
TO
MONO
INPUT
JACK OF
EFFECT
TIP: LINE IN (RETURN)
RING: LINE OUT (SEND)
SLEEVE: GROUND
(IF EFFECT IS INVER
TING)
TO
INSERT
JACK
TO
INSERT
JACK
MONO 1/4" TO
MONO 1/4" CABLES
STP201, 3'
STP202, 6'
STP203, 9'
DUAL MONO 1/4" TO
STEREO 1/4" Y-CABLE
RING
TIP
RING
TIP
TIP: LINE IN (RETURN)
RING: LINE OUT (SEND)
SLEEVE: GROUND
TIP: LINE IN (RETURN)
RING: LINE OUT (SEND)
SLEEVE: GROUND
ABOUT THE INSERT JACK:
The Insert jack (#8) lets you patch external effects into the amplifier just prior to its power amp
stage, as shown below. Set the mix controls on the external effects units to “full effect” (100% wet).
Connecting to the effect’s
insert jack with a stereo cable:
Connecting to the effect with a
stereo-to-mono adapter and cables:
Connecting to the effect with a
stereo-to-mono Y-cable:
THE REAR PANEL
:
25. DC CHARGER PLUG, 15VDC: Plug the
small round connector of the supplied AC
wall adapter into this jack to charge the
internal battery. The LED next to the jack
glows red when the amp is charging. See
page 4 for additional information.
26. DC CIGARETTE LIGHTER ADAPTER, 12
VDC: Plug the small round connector of the
optional 12-volt car adapter into this jack to
play the amplifier from a vehicle, instead of
the internal battery. NEVER connect the
supplied 15-volt charger to this jack! See
page 4 for additional information.
DC CIGARETTE
LIGHTER ADAPTOR
DC CHARGER
PLUG
12V DC
15V DC
LIT WHEN
CHARGING
POSITIVE
NEGATIVE
25
26
