Crary Tile Pro, Owner'S & Parts Manual

Page: 25 / 64

Tile Plow Owner’s/Parts Manual
19 PN:90807-00 R090114
OPERATION
5.8 PARALLEL GRADING WITH A LASER 5.9 PARALLEL GRADING WITH GPS
1. After you have set your laser to grade and are prepared
to lay pipe, lower the plow into trench or starter hole to
your determined depth.
2. With your lift cylinders in lock position adjust the angle
of the plow to the marked position on your gauge rod.
While in the parallel mode the plow should never be
nose high.
3. Begin your hookup to the outlet. Insert your tile down
into the boot and pull through at the bottom and com-
plete your hookup to outlet.
4. Adjust the receiver on the mast until the green light
comes on in the control box. With the bottom cylinder
in the lock position hold tile in place and drive forward.
Watch the grade light on the control box and manually
adjust your lower cylinders up or down to hold the grade.
5. Pull the plow forward about 10’ to 15’ until plow is in
solid ground and all you can see is the tail of the boot.
A good reference point is when the “step” on the boot
goes past the bank of the trench.
6. Be sure you have your grade programmed into the
transmitter and pointed in the upward grade direction.
7. Switch from manual to automatic on the laser control
box and start forward as slow as possible so the laser
can make grade changes. Tile at .8 to 1.2 MPH. Re-
member the slower the better.
8. At the end of the tiling run turn the switch from auto to
manual and lift plow slowly out of the ground while still
moving forward. Pull the top cylinder in completely after
the tile plow clears the ground.
1. After you have done your survey run and are prepared
to lay pipe, lower the plow into trench or starter hole to
a position approximately 1-2” above your determined
depth.
2. With your lift cylinders in lock position adjust the angle
of the plow to the marked position on your gauge rod.
While in the parallel mode the plow should never be
nose high.
3. Begin your hookup to the outlet. Insert your tile down
into boot and pull through at the bottom and complete
your hookup to outlet.
4. If you are uncertain about this pass use your computer
to check it at this time. If and when you are certain the
pass will work move on to the next step.
5. Engage your automatic controls for your #1 SCV. You
will see the letters “AC” in your hydraulic status window.
6. While holding the tile in place start moving forward as
slow as possible so your controller can make grade
changes. Tile at .8 to 1.2 MPH. Remember the slower
the better.
7. At the end of the tiling run turn the switch from auto to
manual and lift plow slowly out of the ground while still
moving forward. Pull the top cylinder in completely after
the tile plow clears the ground.
NOTE
To begin operation be sure to consult the AGPS or Trimble
control system user guide.