6
MODEL
NO
HP VOLT PH NEMA
START
CODE
FULL
LOAD
AMPS
LOCKED
ROTOR
AMPS
CORD
SIZE
CODE
TYPE
CORD
O.D.
± .02 (.5)
in (mm)
WINDING
RESISTANCE
MAIN -- START
ZOGP2072_ _
2
208-
240
1
60
H
17.5-15.0
53.8
"12/3
12/5"
".61 (15.5)
.71 (18)"
1.2--3.2
ZOGP2082_ _
2
208-
240
3
60
L
8.5-8.2
43.9
12/4
.67 (17.0)
1.6
ZOGP2042_ _
2
480
3
60
L
4.6
22.0
12/4
.67 (17.0)
6.4
ZOGP20X2_ _
2
230
1
50
H
17
65.0
"12/3
12/5"
".61 (15.5)
.71 (18)"
1.7--5.5
ZOGP20Y2_ _
2
220
3
50
L
9
43.9
12/4
.67 (17.0)
5.1
ZOGP20Z2_ _
2
380
3
50
L
5.2
26.3
12/4
.67 (17.0)
10.2
Winding Resistance ± 5%, measured from terminal block.
Pump rated for operation at ± 10% voltage at motor.
For 3 Phase Models: Temperature Sensor Cord is 14/3 SOW. .55 (14mm) ± .02 (.51mm) OD
Recommended Breaker Sizes
Pump Model
HP
Phase
Volts
Frequency
Breaker Size
ZOGP2072_ _
2
1
208-240
60
25
ZOGP2082_ _
2
3
208-240
60
15
ZOGP2042_ _
2
3
480
60
10
ZOGP20X2_ _
2
1
230
50
25
ZOGP20Y2_ _
2
3
220
50
15
ZOGP20Z2_ _
2
3
380
50
10
The nameplate is located on the side of
the pump. This contains the pumps part
number, horsepower voltage, phase, and
serial number, as well as other information.
The start-up form located in the back of this
manual contains a place to record this data.
The information should be recorded now
so the pump does not have to be pulled
again later. The start-up form can be left
in the control panel until station start-up is
completed later.
Tie the bowline knot where shown per the
directions provided (Steps 1 through 5).
On the CC series, tie one bowline knot on
the moveable fitting and one bowline knot in
the handle on the pump (See Fig 1).
On the CT (Not Shown) series tie bowline
knot on the handle.
