Crane Barnes PS Omni Grind Plus OGP2022CO Series, Installation Manual

Page: 5 / 20

5
DISCHARGE ....................... 1¼” Vertical, Bolt-on Flange
LIQUID TEMPERATURE .... 104°F (40°C) Continuous
MOTOR HOUSING ............. Cast Iron ASTM A-48, Class 30
VOLUTE .............................. Cast Iron ASTM A-48, Class 30
SEAL PLATE ...................... Cast Iron ASTM A-48, Class 30
IMPELLERS
Design ............ 12 vane, vortex, with pump out vanes
on back side. Dynamically balanced,
ISO G6.3
Material ........... 85-5-5-5 Bronze (Std) or Cast Iron
ASTM A-48, Class 30
SHREDDING RING ............. Hardened 440C Stainless Steel
Rockwell® C-55
CUTTER .............................. Hardened 440C Stainless Steel
Rockwell® C-55
SHAFT ................................. 416 Stainless Steel
SQUARE RING ................... Buna-N
HARDWARE ....................... 300 Series Stainless Steel
PAINT .................................. Air dry enamel, top coat
SEAL Design ............. Single Mechanical, oil fi lled reservoir
Material ........... Rotating Faces - Silicon-Carbide
Stationary Faces - Silicon-Carbide
Elastomer - Buna-N
Hardware - 300 series stainless steel
CORD ENTRY ..................... 15 Ft. (4.5M) Cord, Custom Molded
Quick Connected for sealing and
strain relief
CORD .................................. CSA/UL Approved 12/5, Type SOW
SPEED ................................ 3450 RPM, 60Hz
UPPER BEARING:
Design ............. Single Row, Angular Contact Ball
Lubrication ...... Oil
Load ................ Radial & Thrust
LOWER BEARING
Design ............. Single Row, Angular Contact Ball
Lubrication ...... Oil
Load ................ Radia & Thrust
MOTOR Design ............. NEMA L, Oil Filled,
Squirrel Cage Induction
Insulation ........ Class F
SINGLE PHASE .................. Capacitor start/capacitor run
SUPPORT PLATE ............... 300 Series Stainless Steel with
Nitrile Grommets, Stainless Hardware
and Polypropylene Rope
LEVEL CONTROL .............. Model ESPS-150, Environmentally
sealed pressure switch with CPVC
housing, Buna diaphragm, Custom
Molded Quick Connect for Sealing
and Strain Relief
CHECK VALVE:
Body ................ Cast Iron ASTM A-48, Class 30
Seat ................ Bronze ASTM C836
Flap ................. Fiber Reinforced Buna
OPTIONAL EQUIPMENT .... Cord lengths, Rope lengths
PUMP SPECIFICATIONS:
inches
(mm)