Crane 029676, Installation And Operation Manual

Page: 4 / 12

4
SUCTION/DISCHARGE . 2” (51mm) NPT Suction, 2” (51mm)
Discharge, 125 lb Flange.
Discharge can be placed in 8
defferent locations depending on
piping requirements
LIQUID TEMPERATURE 180°F (82°C) Continuous
BODY ............................. Cast Iron ASTM Class 30, with Air
vent, Vacuum pressure and drain
plugs.
PEDESTAL ..................... Cast Iron ASTM A Class 30
IMPELLER
Design ........... Enclosed type
Material ........ 81-3-7-9 Bronze
Dynamically Balanced, ISO G6.3
WEAR RING ................... Tefl on “U” cup
SHAFT ............................ Steel
SHAFT SLEEVE ............ Bronze
HARDWARE .................. Steel
PAINT ............................. Air dry enamel
SEAL: Design .......... Single Mechanical
Lubrication .... Self-Lubrication
Material ........ Rotating Faces - Carbon
Stationary Faces - Ni-Resist
Elastomer - Buna-N
Hardware - 300 series stainless steel
BEARING-PUMP END:
Design .......... Single Row, Ball
Lubrication .... Grease, Factory Lubrication
Load ............. Radial & Thrust
BEARING-DRIVE END:
Design .......... Single Row, Ball
Lubrication .... Grease, Factory Lubrication
Load ............. Radial & Thrust
OPTIONAL EQUIPMENT: Discharge Check Valve, Hand
Primer, Base & OSHA Coupling Guard, Flex Coupling,
Strainer.
SECTION: A - PUMP SPECIFICATIONS:
inches
(mm)
IMPORTANT!
1.) DO NOT USE FOR PUMPING FLUIDS WITH A FLASH POINT OF LESS THAN 100°F.
2.) MAKE CERTAIN THAT PUMP AND/OR MOTOR ASSEMBLY AND CONTROLS HAVE THE APPROPRIATE RATINGS FOR THE GIVEN
APPLICATION AREA CLASSIFICATION (ie DIVISION I, AGENCY LISTING ETC.)