HARDWARE SETUP
The diagram above details the steps required in order to connect N8 to your recording
system and C.A.S.T.-enabled devices.
1.
Connect the DB25
Output
Connector
[4]
to the Mic/Line
Inputs
1-8 of your
audio interface.
2.
Connect the DB25 Input Connector
[3]
to the Line Outputs 1-8 of your audio
interface.
3.
Connect the C.A.S.T. Output of any C.A.S.T.-enabled device to the C.A.S.T.
Input
[1]
of N8 using a shielded Cat 5e, Cat 6, or Cat 7 cable.
4.
Connect your Mics or Line sources into the Inputs of the connected
C.A.S.T.-enabled device.
5.
Connect the Outputs of the C.A.S.T.-enabled device to your desired
destination such as a speaker, monitor, or recording device.
Once set up, mic/line sources connected to Inputs 1/2 of the C.A.S.T. device will be sent
through C.A.S.T., through N8, out of channels 1/2 on the DB25 Output Connector
[4]
and into Inputs 1/2 of your audio interface.
At the same time, Outputs 1/2 from your audio interface are sent into inputs 1/2 on N8’s
DB25 Input Connector
[3]
, through the same C.A.S.T. cable, and to outputs 1/2 of the
connected C.A.S.T. device.
Page 4
©2022 Cranborne Audio Ltd
