Leaf and litter vacuum
Original Operation Manual
English -13
8.3
Maintenance work
ATTENTION!
Risk of injuries by combustion motors
Cleaning and repair work must never be carried out
during operation or when the machine runs idle, since
this may result in burns and cuts.
Stop machine and motor and let them cool down.
Disconnect the spark plug connector.
8.3.1
Check safety precautions
Safety precautions comprise:
- Discharge covers
- Vacuum nozzle
The machine must not be operated if the covers show any signs of
damage or are removed. They are to be replaced in case of damage
or loss. The machine must not be started without safety precautions.
8.3.2
Check vacuum nozzle and fan rotor for damage
1
Switch off the machine and leave it to cool down.
2
Use the wrench to unscrew the bolt on the vacuum nozzle (the
wrench is supplied with the machine)
3
Pull the vacuum nozzle upwards and out of the retainer
4
Remove any foreign objects from the vacuum nozzle
5
Check the fan rotor for foreign objects Remove all foreign
objects. If damaged, the rotor must be replaced.
6
Insert the vacuum nozzle into the retainer and secure using the
bolt.
8.4
Cleaning work
The machine should be cleaned regularly so that damage to the
paint coating or plastic components can be detected. Please
observe the notes listed for cleaning in order to avoid damage to the
electronics.
8.4.1
Machine cleaning
After every use, clean the outside of the machine and check it for
damage.
1. Park the machine on an even surface before cleaning it.
2. Clean the machine with a soft brush.
3. If necessary, then clean the machine with a damp cloth.
NOTE !
Machine damage!
Do not clean the machine with spray water.
8.4.2
Cleaning the collection bag
Remove the collection bag from the machine. When cleaning with
water, the collection bag must first be detached from the support
frame. Turn the collection bag inside out to wash it
The following cleaning methods may be used:
•
Beat the dirt out of entire collection bag
•
Clean in bath of water
•
Clean under running water
•
Clean at professional cleaners
Subsequently allow the collection bag to dry out completely.
Clean the zip with a soft brush and occasionally rub with talcum. Re-
attach the dry collection bag. See page 17 for attaching the
collection bag.
8.4.3
Cleaning the vacuum nozzle
The vacuum nozzle must always be dismantled for cleaning. Use the
tool (wrench) attached to the machine frame in order to dismantle
the vacuum nozzle.
1. Switch off the machine and leave it to cool down
2. Use the wrench to unscrew the bolt on the vacuum nozzle
3. Remove the vacuum nozzle from the retainer
4. Remove any foreign objects from the vacuum nozzle
