Sweeper H
Original Operation Manual English
-9
6
Operation
6.1
Activities prior to use
Basic setting
Height of sweeping brush is set
Fuel tank is filled
Throttle is set to
O
.
6.2
Start and stop
Start
1. Move throttle to Choke
2. Pull starter rope
3. Motor is running
4. Move throttle to FULL THROTTLE
Stop
1. Move throttle to
O
2. Motor is off
Emergency stop
Immediately move throttle to
O
.
6.3
Normal operation
WARNING !
Risk of injuries by highly flammable
materials and heat!
Materials coming into contact with a hot surface may result
in serious burns on the body when they inflame; e.g. hot or
burning materials such as coal.
Keep highly flammable materials away from the
machine.
Do not move the machine over any spilled fuel or
similar substances.
Start the machine.
•
Activate brush drive.
•
Activate operation drive handle.
•
Move machine across the area to be swept
•
Adjust brush on the left or right in order to sweep dirt
aside.
Stop machine.
6.4
Brush settings
Height setting of sweeping brush by adjusting the support
wheel:
•
The bristles of the sweeping brushes should just touch
the ground
•
Turn crank to the left: Sweeping brush is lowered
•
Turn crank to the right: Sweeping brush is lifted.
An excessively low setting results in an overload of the drive
and in inappropriate wear of the sweeping brushes.
6.5
Brush inclination
In order to sweep dirt to a specific side:
Set brush to the left or to the right.
6.6
Activities after use
1. Stop the motor.
2. Where applicable, close the petrol tap.
3. Roughly remove dirt and sand by using a soft hand
brush.
4. Check the general condition of the machine and remove
any tapes or wires wrapped around the brushes
5. The machine must be left in a clean and dry condition.
