1. INSTALLATION AND USE
FT190S
1 - 3
•
Selection of the character dimensions (normal, double width, double
height, expanded)
•
Selection of the font (font 1 or font 2)
•
Enabling or disabling of the CR command
•
AUTOFEED enabling or disabling : if the function is enabled when the
printer receives a characters number equal to the line buffer the next
character will place on the left margin in a new line
•
Selection of the print speed in function of the absorption
•
Selection of the red intensity : using two-colour thermal paper is
possible to set different red tonality
•
Selection of the parameters for serial communication
•
Enabling or disabling of the 1Kbyte buffer
•
Enabling setting of the real time clock
•
Enabling of seconds printing in the real time clock function
The settings made are saved on the EEPROM (non volatile memory).
1.3 AUTOTEST
To run the autotest, hold down the FEED key, while switching on the printer.
The autotest causes the printing of the printer’s current setting data and the
printing of the complete ASCII character set.
1.4 HEXADECIMAL DUMP
If the PRINT key is held down during switching on, the printer enters
Hexadecimal Dump mode. This function is used for the diagnostics of
characters received in serial. In fact, these are printed in hexademical code
together with the corresponding ASCII code.
