7
Important: Formatting the Micro SD Card will delete all the data on the card. Download the
data to your computer before formatting the card.
USB Host (Full size USB port)
This device supports USB device for extending the memory size, or USB Thumb Driver/3G
Driver, insert it to the USB Host on the side of unit.
Notes:
A. Before replacing the USB driver, make sure the unit has been powered off.
B. When inserting the USB driver, make sure the direction you selected is correct. Never
insert violently to avoid damaging the USB driver or the unit. If it doesn’t work, please
check if the direction is correct.
Power On/Off the Device
A.
Press and hold the
button on the top of cabinet approximately 3 seconds to power
on the unit. Touch and slide the key bar shown on the screen to right to unlock.
B.
In power on mode, press the
button to turn off the screen for saving battery power.
Press again to turn it on .
C.
To power off, press and hold the
button until the
“Power off " window pop up , touch
the "OK" button as on screen instruction to power off the unit.
Notes:
z
Like your computer, after turning on the Device, you may have to wait a short while
to let the operating system boot up before the home page appears on the screen.
Reset
If the device becomes abnormal, halt, or freezes. Press the RESET Button in the reset hole
with a small screwdriver (not included) to reset the device.
Connections:
Connect to PC
A. Connect the Device to the PC via the Mini USB port on the side of cabinet to the USB port
on your PC by the supplied connection cable.
B. Wait a few seconds, the (
) will appear on the bottom-right screen. Touch and slide it
upward , the follows picture will appear: