3
2. The unit will automatically power on and the voltage of the vehicle battery
will appear on the LED Display on the unit as illustrated below:
3. A few seconds later, the FM radio frequency will appear on the LED Display
as below:
4. Turn on your car radio and place the radio in to FM mode as usual. Search
for a blank FM channel without any radio signal received (For example, set
it to 107.0 MHz).
5. Press and hold the
Button approximately 5 seconds until the FM radio
frequency on the LED Display starts blinking.
6. Press the
or
buttons repeatedly to set or reset the FM radio
frequency to your radio. (In this example, set it to 107.0 MHz).
Step 2:
Pair your BT (Bluetooth) Device to the unit:
In first time use or re‐pairing the unit to a new BT Device, pair it as below:
1. Power on and pair the unit to your car radio as step 1.
2. You will hear an audible prompt say “Bluetooth ready for connection”.
3. Power on the external BT Device and enter to BT searching mode. Start
pairing following the on screen instructions from the external BT Device.
4. When paired, the unit will sound a prompt “Bluetooth connected”.
5. If pairing is complete you may now play music and answer the phone with
your external BT Device and car radio.
6. During playback:
Press the
Button to pause; press again to resume to normal
playback.
Press and hold the
or
buttons to adjust volume level as desired.
Or, using the volume controls on your car radio/paired BT Device to
adjust volume level.
Press and release the
or
buttons repeatedly to skip tracks.
7. If the unit is paired to a Cell Phone:
If a call is incoming during an active music session. Press the
Button
then speak to the Microphone to answer the call. When your call is
complete, press the
Button to disconnect or end the call and
resume to music playback.
Or, press and hold the
Button approximately 3 seconds to decline
the incoming phone then resume to music playback.