CraftUnique CraftBot, User Manual

Page: 3 / 50

*Always operate the CraftBot 3D printer with the utmost care, for both the machine
and the user’s wellbeing. Respect the machine!
*Never force anything, whether it be during unpacking, setup, operation, service.
Never!
*Never reach inside the machine when turned on. Different parts of the machine
(mainly the
extruder and heated buildplate) operate at very high temperatures and can cause
severe burns. The moving parts can also cause pinching and crushing injuries.
There is also a risk of electric shock when reaching inside.
*Make sure that the power supply is off and that the power cord is disconnected
before servicing. Allow at least 5 minutes for the device to cool down after unplug-
ging it before reaching inside to service.
*Service and oil the suggested parts as often as recommended. Never use a sub-
stance to do so that is not recommended by us personally.
*Never leave the CraftBot unattended while it is plugged in, and especially when it
is operating.
*Always turn off the printer and disconnect from the computer when it is not being
used.
*Never, ever operate the CraftBot if something is not running “as usual”
*In the case of an emergency, immediately disconnect the printer from power and
the computer.
*If you are working with material other than PLA, operate the machine in an open
space with the necessary ventilation which allows the fumes to dissipate. Breath-
ing in unnecessary fumes can result in health hazards and sickness.
*an open area is also recommended for PLA use, even though PLA is a relatively
safe material.
RECOMMENDED USE AND WARNINGS
3 Recommended use and warnings