14
SNOW CHUTE ASSEMBLY
NOTE: The chute ring assembly (A, Figure 10) comes installed on the unit
from the factory.
1. Turn crank assembly (Figure 4) until the arrow on outer ring (B
B, Figure
10) of chute ring assembly points forward.
NOTE: Make sure the slot in the chute ring aligns with the arrow on the
outer ring.
2. Install chute deflector (C
C) using four screws (D
D) and nuts (EE) in holes
as shown. The chute deflector must point forward for proper installa-
tion.
3. Tighten screws snugly but be careful not to over-tighten.
Snow Chute Assembly
Figure 10
HEADLIGHT ASSEMBLY
The headlight is mounted on the right side of the upper handle. It is in-
stalled upside-down for shipping purposes.
1. Remove the nut (A
A, Figure 11) and lockwasher (B
B) from the carriage
bolt (C
C).
2. Turn the headlight (D
D) to the top side of the upper handle (EE). Ensure
external tooth lockwasher (FF) and saddle washer (G
G) are in place as
shown in Figure 11.
3. Install the nut and lockwasher to secure the headlight to the handle.
The headlight should point toward the snow clearing path.
Headlight Assembly
Figure 11
ASSEMBLY
C
C
A
B
D
E
D
C
E
G
F
B
A
Not
for
Reproduction
