16
SERVICE AND MAINTENANCE
WARNING
Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to
prevent unintended starting. Always wear safety glasses during operation
or while performing any adjustments or repairs.
Follow the maintenance schedule given below. This chart describes service
guidelines only. Use the Service Log column to keep track of completed
maintenance tasks. To locate the nearest authorized service center or to schedule
service, call the following toll free number: 1-888-331-4569.
MAINTENANCE SCHEDULE
Interval
Item
Service
Service Log
Each Use and every 5 hours
1.
Engine oil level
2.
Unit and engine.
1.
Check
2.
Clean
1st 2 hours and every 10 hours 1.
Drive belt tension
2.
Loose or missing hardware
3.
Tiller
1.
Check
2.
Check, tighten or replace
3.
Lubricate
Annually or 25 hours
1.
Air filter
2.
Control linkages, pivots, & wheels
3.
Underside of deck
1.
Clean
2.
Lube with light oil
3.
Clean
Every 30 hours
1.
Gear oil level in transmission
2.
Tines for wear
3.
Tire air pressure
1.
Check
2.
Check
3.
Check
Annually
1.
Spark plug
2.
Air Filter
1.
Replace
2.
Replace
Before Storage
1.
Fuel system
1.
Run engine until it stops from lack of fuel, or
add stabilizer to a full tank of fresh fuel prior
to storage.
† Clean more often under dusty conditions or when airborne debris is present.
WARNING
Before inspecting, cleaning or servicing the machine, shut off the engine,
wait for all moving parts to come to a complete stop, wait for the engine to
cool, disconnect the spark plug wire and move the wire away from the spark
plug. Failure to follow these instructions can result in serious personal injury
or property damage.
Maintenance
Engine
Refer to the Engine Operator’s Manual packed with your tiller for all engine
maintenance.
Tire Pressure
Check the air pressure in both tires. The air pressure should be between 15-20 PSI.
Keep both tires equally inflated to help prevent machine from pulling to one side.
Hardware
Check for loose or missing hardware after every 10 operating hours and tighten or
replace (as needed) before using tiller.
Be sure to check the screws underneath the tiller hood that secure the transmission
cover and the Depth Regulator Lever to the transmission.
Lubrication
After every 10 operating hours, oil or grease the lubrication points shown in Figure 23.
Wheel Shaft
Tine Shaft
Handlebar
Attaching
Screws
Depth
Regulator
Lever
Figure 23
Summary of Contents for CMXGVAM1144036
Page 20: ...NOTES 30 ...
