Craftsman CMXEVCVVJH1211, Instruction Manual

Page: 5 / 40

5
ENGLISH
2. Lift the power head 12 off the collection
tank 10 .
3. Remove the contents from inside the
collection tank 10 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four caster feet 7 into the slots
on the collection tank and tighten with
supplied screws
14 . Verify that the caster
feet 7 are mounted correctly. Do not over-
tighten screws. Fig. 1 .
Fig. 1
GENERAL SET UP
5. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 6-7 for installation
instructions.
6. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 8 for the foam wet filter
installation instructions.
7. Place the power head back on the collection
tank and secure into place using the latches.
8. Insert the larger end of the hose 15 into the
vacuum port on the collection tank 10 and
lock into place. Fig. 2 .
9. Choose the desired accessory 17 18 19
and/or extension wands
16
and insert onto
the end of the hose 15 . Fig. 3 .
Fig. 3
10. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch
13
to the ‘I’ ON position and begin
vacuuming. Fig. 4 .
Fig. 4
WARNING:
ONCE YOU HAVE
COMPLETED VACUUMING, FLIP THE
ON/OFF SWITCH TO THE ‘O’ OFF POSITION
AND UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF I = ON
BLOWER OPERATION
This Wet/Dry Vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
Fig. 2