Craftsman CMXEVCVVFB511, Instruction Manual

Page: 10 / 44

10
ENGLISH
NOTICE: The foam wet filter must be removed
after wet vacuuming and the cartridge filter
must be installed before dry vacuuming again.
FOAM WET FILTER INSTALLATION
AND CLEANING:
WARNING:
VERIFY THAT THE
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
25. Remove the power head and place in an
upside down position. Follow instructions
to remove the cartridge filter on page 8-9.
26. Carefully slide the foam wet filter 19 down
over the filter cage making sure the cage is
completely covered. Fig. 17 .
Fig. 17
27. To remove the foam wet filter, place the
removed power head in an upside down
position, and carefully remove the foam
wet filter
19 . Fig. 18 .
Fig. 18
28. Use a mild soap and water solution to
wash the foam wet filter 19 and rinse with
clean water. Fig. 19 .
29. Allow the wet filter to air dry for 24 hours
before installing onto the filter cage.
EMPTYING LIQUID WASTE FROM
THE TANK
WARNING:
VERIFY THAT THE
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
30. Disconnect the hose 12 from the vacuum.
31. Undo the latches 4 and remove the
power head 8 from the collection tank
6
. Place power head
8
on a soft, clean
surface upside down.
32. After use, empty the collection tank 6
clean and dry the inside and outside before
storage. Fig. 20.
Fig. 20
STORAGE
Before storing your vacuum, the collection
tank should be emptied and cleaned. The
accessories should be cleaned and stored
so they can be readily available when
needed. Store the wet/dry vacuum indoors.
Fig. 19