Craftsman CMXEVBE171550, Instruction Manual

Page: 7 / 44

Powerhead
Assembly
Hose
Hose Wrap
Area
Carry Handle
Cord Wrap
Area
Cord Clip
Polarized
Plug
7
Fig. F
Insert Hose (Fig. F)
Insert the Locking End of the Hose into the Vacuum Inlet
Port. The Hose should snap into place.
Optional: Place the Utility Nozzle securely on the opposite
end of the Hose. The Vacuum is ready for use.
To Remove the Hose from the Vacuum: Press the
Release Button in the Hose Assembly and pull the Hose
out of the Vacuum Inlet Port, as shown.
Vaccum
Inlet Port
Locking End
of Hose
Power Cord Storage (Fig. H)
The Power Cord should be wrapped around the Carry
Handle.
Snap the Cord Clip onto the Power Cord, to secure in place.
Fig. H
WARNING:
To prevent serious injury from electrical shock,
stop vacuum use immediately if the power cord is
damaged. Take the vacuum to a qualified service dealer
for inspection and possible repair.
!
CAUTION:
Do not operate vacuum while the hose or
accessories are stored on the wet/dry vacuum’s
powerhead assembly.
Fig. I
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings blocked;
keep free of dust, lint, hair or anything that may reduce
air flow.
!
!
Fig. G
Accessory Storage (Fig. G)
Your Craftsman Wet/Dry Vacuum Accessory Storage is
located at the bottom of the Vacuum on the Caddy.
Slide the Extension Wands onto the Posts of the Caddy
for storage.
Place each Accessory (Utility Nozzle and Car Nozzle) onto
the top of each Extension Wand for storage.
To Remove Wands and Accessories: Lightly rotate and
pull upward.
DRA
IN
DRA
IN
Caddy
Car
Nozzle
Utility
Nozzle
Extension
Wands
Hose Assembly Storage (Fig. I)
Wrap the Hose around the top of the cooled Powerhead
Assembly, as shown.