ENGLISH
Assembly Instructions
20. To remove portable blower
3
from tank cover, pull
blower latch down to unlock blower
3
Fig. 5
, grasp
both blower handles and pull in an upward motion.
Fig. 6
.
21. Insert 2-1/2” extension wand
11
(B)
into the blower
exhaust
(A)
. Push firmly into place by twisting wand
11
slightly. Attach desired accessory
(C)
.
Fig. 7
.
22. Plug the cord into an electrical outlet. Your portable
blower
3
is ready for use.
NOTE:
If an extension cord is
used, use only an approved outdoor extension cord. To
prevent extension cord from pulling away from appliance
cord, tie cords as shown.
Fig. 8
.
23. To clean inlet shield and foam pad, disconnect cord from
receptacle and remove screws on bottom side of power
unit.
Fig. 9
.
24. Once removed, run foam pad under running water and
blot with clean towel to dry.
25 After cleaning, replace inlet shield and foam pad and
secure with screws.
NOTE:
Inlet shield will only fit properly
one way.
Fig. 10
.
CAUTION:
DO NOT OPERATE
BLOWER WITHOUT INLET SHIELD AND FOAM IN
PLACE.
BLOWER OPERATION
26. The correct operating position is to hold the portable
blower
3
in either hand, at arms length at your side.
Your portable blower
3
has been designed with the
necessary angle to direct the air blast toward the ground
in front of you.
Fig. 11
.
Fig. 5
Fig. 6
A
B
C
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
5
Summary of Contents for CMXEVBCB1260L
Page 23: ...SPANISH ...
Page 36: ...FRENCH 13 ...
