3
English
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to ratio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause interference in other
devices, the user is encouraged to try to correct the interference
by one or more of the following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help.
NOTICE:
Per FCC Part 15, changes or modifications to this
equipment not expressly approved by CRAFTSMAN could void
your authority to operate this equipment.
This Class B digital apparatus complies with Canadian ICES-
003.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This work light is suitable for Indoor/Outdoor Use. The work
light has wet locations rating, can be used outdoor in rain or
wet conditions.
DO NOT
use in presence of flammable liquids or gases.
DO NOT
let children come into contact with the work light.
Supervision is required when inexperienced operators use
this work light.
Specifications
Model
CMXELAYMPL1028
Power
46 Watts
Brightness
4,500 Lumens
Color Temperature
4000K
Color Rendering Index
80
Input Voltage
AC 120V 60Hz
Location Rating
Wet Locations
Power Cord
5 ft
Net Weight
4.23 Lbs.
UNPACKING
WARNING:
It is unlikely the product is faulty or has
a missing component. If you find product is faulty,
do not operate the product until the parts have been
replaced or the fault has been rectified. Failure to do so
could result in serious personal injury.
Remove work light from carton and discard all packaging.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect it from power
source and put it on a stable secure position
before making any adjustments or removing/
installing attachments or accessories.
WARNING:
Risk of unsafe operation. When
performing maintenance, you may be exposed to
voltage sources. Personal injuries can occur. Before
performing any maintenance, disconnect power
source from the work light.
The work light is fully assembled out of the box.
Unfold Work light (Fig. A, B, C)
Unfold the base
10
from the frame
8
to desired angle, as
shown in Fig. C.
Fig B.
10
8
75°
Fig C.
Limitation Mark
WARNING:
The angle between frame and base is
limited to 75
degrees, the limitation mark is shown in
Fig C.
NEVER
adjust the frame beyond the maximum
limitation mark position.
NOTICE:
If work light does not stay in desired position,
simply tighten the pivot screws. DO NOT OVER-TIGHTEN.
Adjusting Light Direction (Fig. A, D)
WARNING: To reduce the risk of serious personal
injury, turn work light off and disconnect it from
power source before making any light direction
