15
English
Tilting The Table (Fig. CC)
1. TIGHTEN the nut
39
on the locking pin
40
using a
10 mm or adjustable wrench clockwise to RELEASE the
locking pin
40
from the table support.
2. Loosen the bevel lock bolt
3
using a 19 mm or
adjustable wrench and tilt the table
20
to desired bevel
angle.
3. Re-tighten the bevel lock bolt
3
.
WARNING:
To prevent injury, be sure to hold the table
and table arm assembly, so it will not swivel or tilt.
WARNING:
To avoid injury from spinning work or
tool breakage, always clamp workpiece and backup
material securely to the table before operating the
drill press.
4. To return the table to its original position, loosen the
table bevel locking bolt
3
. Return the table
20
to the
0° position.
5. Return nut
39
on locking pin to the OUTSIDE END OF
THREADS. Gently tap locking pin until it is seated in the
mating hole of the table bracket. Hand tighten nut
39
.
Fig. AA
Fig. BB
19
54
20
60
Fig. CC
20
3
40
39
Feeding
1. Pull down the feed handles with only enough effort to
allow the drill bit to cut.
2. Feeding too slowly might cause the drill bit to burn.
Feeding too rapidly might cause the belt or drill to slip,
tear the workpiece loose or break the drill bit.
3. When drilling metal, it is necessary to lubricate the drill
bit tip with oil to prevent burning of the workpiece and
bit.
