ASSEMBLY
Your electric pressure washer requires some assembly but is
quickly ready for use.
If you have any problems with the assembly of your pressure
washer, please call the pressure washer helpline at 1-866-902-
9690.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton.
2. Ensure you have all included items prior to assembly.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call the
pressure washer helpline at 1-866-902-9690.
• Main unit
• Spray gun
• High pressure hose
• Plastic wand
• Quick connect tips (3)
• Parts bag (which includes the following):
• O-ring Kit
• Operator’s manual
Become familiar with each piece before assembling the pressure
washer. Identify all contents with the illustration on page 5. If any
parts are missing or damaged, call the pressure washer helpline
at 1-866-902-9690.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Lubricate o-rings.
2. Connect pressure hose to spray gun and pump.
3. Connect water supply to pump.
4. Attach plastic wand to spray gun.
5. Attach quick connect spray tip to plastic wand.
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation and
operation. The use of a lubricant (petroleum or synthetic grease)
during assembly helps seat o-rings properly and provides an
improved seal. It also helps protect the o-ring from damage by
abrasion, pinching or cutting and extends the life of the o-ring.
NOTICE
ALWAYS apply a small amount of lubricant on o-rings
prior to assembling the high pressure hose (pump end) and high
pressure hose (gun end) (A), plastic wand (gun end) (B), and
garden hose to the pump (C)
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to lubrication
and assembly.
2. Use lubricants sparingly during assembly; a light film is all
that is required.
3. Use a small brush or cotton swab to apply grease directly
to o-rings where they are not accessible (QC fitting, M22
fitting).
6
A
B
C
