16
SERVICE AND ADJUSTMENTS
Fig. 24
CABLE CLIP
SCREW
DRIVE
CONTROL
CABLE
EXTENSION
SPRING
ENGINE
PULLEY
IDLER
PULLEY
TRANS MIS SION
PULLEY
LESS
TEN SION
5/8"
MORE
TEN SION
TO REPLACE GROUND DRIVE BELT
(See Figs. 23 and 24)
•
Remove belt guard as described in “TO REMOVE BELT
GUARD”.
•
Remove old belt by slipping off engine pulley first then
remove from transmission pulley.
• Place new belt in groove of transmission pulley and
into engine pulley. BELT MUST BE IN GROOVE ON
TOP OF IDLER PULLEY. NOTE POSITION OF BELT
TO GUIDES.
• Check belt adjustment as described below.
• Replace belt guard.
• Reposition wheel and replace clevis pin and hairpin
clip.
GROUND DRIVE BELT ADJUSTMENT (See
Fig. 24)
For proper belt tension, the extension spring should have
about 5/8 inch (16 mm) stretch when drive control bar is
in “EN GAGED” position. This tension can be attained as
fol lows:
• Loosen cable clip screw securing the drive control
cable.
• Slide cable forward for less tension and rearward for
more tension until about 5/8 inch (16 mm) stretch is
obtained while the drive control bar is engaged.
• Tighten cable clip screw securely.
Summary of Contents for 944.629673
Page 32: ...32 SERVICE NOTES ...
Page 33: ...33 SERVICE NOTES ...
Page 34: ...34 SERVICE NOTES ...
Page 36: ...ª ª ªªªª ª ª ª ª ª ª ª ª ª ª ª ª ª ª ª PRINTED IN U S A 02 02 12 TH ...
