16- ENG
D25079
Air Cleaner
To Remove
1.
Loosen screw and tilt cover
down.
2.
Remove air cleaner.
3.
Reinstall clean (or new) air clean-
er assembly inside cover. Lip of
pre-cleaner must be at bottom of
cartridge pleats.
4.
Insert cover’s tabs into slots in
bottom of base.
5.
Tilt cover up into place and tight-
en screw.
To Clean
Separate pre-cleaner from cartridge
and wash in liquid detergent and
water. Air dry thoroughly. Do not oil.
Reassemble dry pre-cleaner on clean
cartridge.
Do not use pressurized air or solvents
to clean cartridge. Pressurized air can
damage cartridge; solvents will dis-
solve cartridge.
Clean and Replace Spark Plug
Change the spark plug every 100
hours of operation or once each year,
whichever comes first. This will help
your engine to start easier and run
better.
Resistor
.030” (0.76 MM)
Wire Gauge
To Change Oil
Drain the engine oil when the engine
is warm. Warm oil drains quickly and
completely.
1.
Before tipping engine or equip-
ment to drain oil, drain fuel from
tank by running engine until fuel
tank is empty.
2.
Disconnect spark plug wire and
keep it away from spark plug.
3.
With engine OFF but still warm
remove filler cap/dipstick.
4.
Place a suitable container next
the engine to catch the used oil.
5.
Keeping air claner above oil out-
let, drain oil.
NOTE:
Please dispose of used motor
oil in a manner that is compatible with
the environment. It is recommended
to take used oil in a sealed container
to your local recycling center or serv-
ice station for reclamation. Do not
throw it in the trash or pour it on the
ground or down a drain.
6.
With the engine in a level posi-
tion, fill to the FULL line on the
dipstick with SAE 10W-30 oil.
Engine oil capacity is 20 oz. (0.6
liter).
NOTE:
Other viscosities shown in the
chart in the “To Check Oil” paragraph
may be used.
7.
Replace the oil filler cap/dipstick
securely.
Cartridge
Pre-
Cleaner
Tabs
and
Slots
Cover
Base
Pre-Cleaner Lip
Air Cleaner
Drain Oil
Screw
Cartridge Lip
