MODEL: LTS-04C
SURGE PROTECTIVE DEVICES
RATING: 15A 125VAC 60Hz 1875W
USB:TOTAL 2.1A
USB O/P: IT EQUIPMENT ONLY
VPR:700V (L-N) TYPE 3 SPD
CONFORMS TO UL STD. NO. 1363 AND ANSI/UL STD.
NO. 1449
CERTIFIED TO CSA STD. C22.2 NO.
308
&
8
POWER STRIP SPECIFICATIONS.
•
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user'
s
authority to operate the equipment.
WARNING: RISK OF ELECTRIC SHOCK.
To avoid serious injury from electric shock:
- Only use the power strip of this product indoors.
- Only use the power strip of this product in a dry location.
- Do not plug another power strip into one of the power
- Do not plug one of the power strips of this product into
strips of this product.
another power strip.
3
Power Strip Cord (Cabinet)
Cut the black strip holding the cord, then pull the white
strip to get the plug out of the cabinet and through the
grommet. Tighten the grommet.
FCC INSTRUCTION
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician
for help.
•
REMOVING DRAWERS
OPERATION
Extend the Slide
Extend the drawer slides from the tool chest/cabinet.
Insert the brackets on each side of the drawer into
the slots in the chest/cabinet slides, being careful that
they are properly positioned. Once properly inserted,
completely close the drawer to set the slides in their
proper positions.
Pull drawer out so that it is almost fully extended.
on one release lever while pulling down on the other release
lever. Pull the drawer outward until it releases from the
drawer slide.
Push up
PUSH DOWN
OTHER RELEASE LEVER
PUSH UP
ONE RELEASE LEVER
Bracket
Open the lid and cut the band attaching the cord to the
pegboard.
Draw the cord and plug through the hole in the back of
the chest as shown.
Power Strip Cord (Chest)
4
INSTALLING DRAWERS
Slide
Black
White
