13
How to Stop Your Cleaning System
1.
Release spray gun trigger and let engine idle for two
minutes.
2.
Move throttle to SLOW position, then STOP position (
A
).
3.
ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT:
Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
4.
Engage trigger lock on spray gun when not in use.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown below.
Follow these instructions to change spray tips:
1.
Engage trigger lock on spray gun.
2.
Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holder provided on the nozzle
extension.
3.
Select desired spray tip:
•
For delicate rinse (lower pressure and higher flow),
for gentle cleaning of cars/trucks, boats, RV’s, patio
furniture, lawn equipment, etc., select white 40°
spray tip.
•
For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select yellow
15° spray tip.
•
For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such as
second story surfaces, paint removal, oil stains, rust
removal or other stubborn substances (tar, gum,
grease, wax, etc.), select red 0° spray tip.
•
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black detergent spray tip.
4.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
Usage Tips
•
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
•
If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
•
DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange spray tips without locking the trigger lock on
the spray gun.
• DO NOT twist spray tips while spraying.
40° White
1750 PSI
2.3 GPM
15° Yellow
2200 PSI
2.2 GPM
0° Red
2550 PSI
2.0 GPM
Black
Use to apply
chemical
Low Pressure
High Pressure
A
