13
• Using the nozzle tip cleaner provided (or an unfolded paper
clip), insert the wire into the nozzle hole and move back and
forth until debris is dislodged.
• Turn the power button off, and back flush water through the
nozzles using garden hose and highest pressure available
(either standard water nozzle or use your thumb over the
nozzle to create water pressure for back flush).
• When your pressure washing session has been completed, turn
off the power switch. Unplug the power cord from the outlet.
Turn off the water supply. Pull the trigger on the spray gun 2-3
times to drain out the excess water and to release any remain-
ing water pressure. Do not allow the power washer to run with
no water flowing through it.
• Remove detergent tank and clean completely.
• Remove high pressure hose from spray gun and unscrew the
other end of the high pressure hose from the power washer.
• Remove lance from the gun. Place the gun in the holder on the
side.
• Make sure to discard any remaining detergent from the tank.
Residual chemical will stick to the container and can cause the
detergent injector to clog and not function properly. Flush the
tank and nozzle head with fresh water to prevent clogging.
• Hook the power cord around the L-shaped tab on the top of the
machine.
• The pressure hose is stored on the hose hook located on the
back of the handle.
•
DO NOT store the power washer where it is exposed
to freezing temperatures unless you use an antifreeze
designed for pumps.
It is recommended that you use this
antifreeze for storing in freezing temperatures. Freezing will
damage the pump unless this is added to the power washer.
If not using or if storing your power washer for more than one
month, it is also recommended that an antifreeze is used to
protect the pump.
STORAGE
OPERATING INSTRUCTIONS
PUMP SAVER
Pump Saver
is a product that protects and prolongs the life of the
pump. This will keep the internal parts of the pump lubricated and
protected from freezing while being stored in ALL climates. It also
assists with protection from internal corrosion. The Craftsman part
# is: PW64511(16oz. bottle).
Pump Saver Instructions
Follow the previous storage instructions for your power
.
To prevent staining, protect the surface under the power washer
from any excess fluid. ear eye protection when using this product.
Turn unit off and disconnect the gun before adding pump saver.
Unscrew threaded top from bottle to remove seal and reattach
threaded top to bottle. Remove black cap from bottle.
1) Place top of pump saver bottle onto the garden hose
adapter previously installed to pressure washer inlet.
2) Secure pump saver bottle by turning in a clockwise direction.
3) Turn power on. Turn the power washer off as soon as the Pump
Savor begins to exit the HP hose.
Note:
Instructions on Pump Saver Bottle are generic and
not model specific
2
1
93988 Craftsman 2-n-1 Pressure Washer119.indb 13
17/11/13 下午4:05
