FILL FROM A BULK
LUBRICANT CONTAINER
1.
While holding grease gun container
tube (
6
), loosen grease gun head (
10
)
two turns.
2.
Pull T-handle (
8
) to extend follower rod
(
5
) fully and slide into slot.
3.
Unscrew container tube (
6
) from
grease gun head (
10
).
4.
Remove empty cartridge (if present)
from container tube (
6
).
5.
Pull T-handle (
8
) back and remove
follower rod (
5
) from slot.
6.
Pack lubricant into cavity of the grease
gun head (
10
) and onto surface of the
follower assembly (
4
).
7.
Insert the open end of the container
tube (
6
) into lubricant.
8.
Pull T-handle (
8
) back while pushing
container tube (
6
) deeper into lubricant
to prevent air pockets from being
pulled into container tube (
6
).
9.
Pull T-handle (
8
) to extend follower rod
(
5
) fully and slide into slot.
10.
Thread grease gun head (
10
) onto filled
container tube (
6
).
11.
Pull lever handle (
3
) away from
container tube (
6
).
12.
Pull T-handle (
8
) back and remove
follower rod (
5
) from slot.
13.
Turn T-handle (
8
) 90° and push into
container tube (
6
)
14.
Loosen grease gun head (
10
) two turns
to expel air and retighten.
!
Notice
If grease does not come out of
coupler (
1
) after ten strokes of lever
handle (
3
), refer to
Expel.Air.Pockets
section on
page.6.
!
Notice
Failure to clean and inspect
grease gun will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
10
4
6
5
8
4
