Release
• Empty the drawer.
• Fully extend the drawer.
removiNG DraWers
Gas spriNGs iNstaLLatioN
items Needed:
Gas Springs (Qty: 2)
5/16 - 18 Ball Studs (Qty: 4)
5/16 - 18 Clip-on Nut (Qty: 4)
1/2-in Wrench
process:
• install (2) 5/16-18 Ball Studs and (2) 5/16-18 Clip-on Nut
into slot on left and right side of cover. Tighten using 1/2-
in wrench.
operatioN
LaBeLs (if appLicaBLe)
process:
• Apply a light film of glass cleaner to the surface where
the label is to be applied.
• Peel the label from the backing and place the label in
position.
• Check alignment of the label and adjust accordingly.
• hold the label in position and squeegee off excess liquid
with a towel, working from the center toward each end of
the label.
• Suggested label location is shown.
• install (2) 5/16-18 Ball Studs into top tray using (2)
5/16-18 Clip-on Nut. (Ball Studs should face towards the
middle of the unit.) Tighten using 1/2-in wrench.
• install Gas Spring as shown in image below by pushing
the sockets onto Ball Studs (cylinder side up).
• Close and open cover to check Gas Springs are properly
installed.
3-1/8
3-3/4
Lever style
- Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
Gas
Spring
5/16 - 18
Ball Stud
5/16 - 18
Ball Stud
5/16 - 18
Clip-on Nut
5/16 - 18
Clip-on Nut
3
