13
―
English
TROUBLESHOOTING
Handle not in position.
Problem
Possible Cause
Solution
Handle locks not tightened.
Tighten handle locking knobs.
Reconnect the cord and use the
cord retainer to keep the cord close
to the motor/blade control.Connect
the extension cord to a live 120V
AC, 60 HZ AC receptacle.
Reset house circuit breaker.
If it trips again, call a quali
fi
ed
electrician.
Have motor control switch replaced
by a quali
fi
ed service dealer using
identical replacement part.
Balance the blade by grinding
each cutting edge equally. Stop
the motor, disconnect the power
source, and inspect for damage.
Have repaired made by an quali
fi
ed
service dealer before restarting.
Move the wheels to a higher posi-
tion. All wheels must be placed
in the same cutting height for the
mower to cut evenly.
Extension cord not connected
to the mower plug. Extension
cord not connected topower
source.Tripped circuit breaker in
the house.Motor control switch
defective.
Lawn is rough or uneven or
cutting height not set properly.
Wet grass clippings sticking to the
underside of the deck.
Wait until the grass dries before
mowing.
Blade is unbalanced or bent motor
shaft.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Mower hard to push.
Raise cutting height.
Mower cutting grass
unevenly..
Mower not mulching
properly.
Mower vibrating at
higher speed
