Assembly (continued)
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank. (Fig. 3)
4. Remove the contents from inside the
collection tank; make sure you have all
contents as listed on page 5. (Fig. 4)
5. With the power head removed, turn the
collection tank upside down. Insert the
two casters into each socket. Apply
pressure until casters snap into place.
(Fig. 5)
6. Insert the rear wheel shaft (N) into the
rear support block. Insert washer (M)
on the shaft, then insert rear wheel (K)
and insert washer again. Insert the
cotter pin (L) into the hole on the end of
the shaft and bend the ends up with the
pliers to lock the wheel. Snap the hub
cap (O) on to the wheel. Repeat the
same steps at the other end of the
shaft. (Fig. 6)
7. Insert the handle into the slots located
on top of the power head. Secure it
6
WARNING:
Do not plug in power
cord to power outlet, make sure plug
is disconnected before assembling
the Wet/Dry Vac.
!
A Philips head screw driver and pliers are required.
with the screws provided. Do not over
tighten the screws. (Fig. 7)
8. For your conveniance the hose storage
rack comes pre-installed. If not installed,
position the hose storage rack as
illustrated. Insert one side of the rack into
the channel making sure it is secured in
place. Squeeze in the other end and
insert it into the corresponding channel
making sure it is secured. (Fig. 8a & Fig
8b) (If the storage rack has already
assemblied on the head skip this step.)
9. Place the power head back on the
collection tank, and secure into place
using the 2 side latches. (Fig. 9 & Fig.10)
10. Insert the locking end of the hose into
the port on the collection tank and turn
to lock in to place. (Fig. 11)
11. Choose the desired accessory and
insert onto the end of the hose. (Fig.12)
Polarized Plug
To reduce the risk of electrical shock, this
appliance has a polarized plug (one with
the blade wider than the other). This plug
will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way. Double insulation eliminates
the need for the three wire grounded power
cord and grounded power supply system.
4
10
12
5
11
2
3
7
1
9
6
N
M
M
M
M
K
K
O
O
8b
8a
