page 7
7. Canopy Assembly.
8. Blade Assembly.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Time Saver
: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 12 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (
located on
the underside of the motor housing
)--
refer
to drawing at right
. [
Be sure to note label on
blade indicating
THIS SIDE UP
and turn
blade so that label faces ceiling.] Insert 3
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note
: Tighten blade attachment screws
twice a year.
hanging bracket
canopy
mounting
screw
anti-sway
adapter
canopy
motor housing
blade plate
blade attachment
screws and washers
blade
Remove 2 screws on underside of hanging bracket.
Lift canopy to hanging bracket. Align holes in
canopy with holes in hanging bracket. While holding
canopy in place, slide anti-sway adapter up to
canopy. Align holes in anti-sway adapter with holes
in bottom of canopy and then re-insert the screws
that were previously removed. Tighten both screws
securely.
Slide canopy cover up to anti-sway adapter, aligning
rounded part of slotted holes in canopy cover with
screw heads in bottom of anti-sway adapter. Turn
canopy cover to the right (clockwise) until it stops.
canopy cover
