page 4
5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [
Refer to
diagram 1
.
]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [
Refer to
diagram 2
.
]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes
in yoke--
make sure wires do not get twisted
.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [
Refer to
diagram 2
.
]
Locate canopy cover and anti-sway adapter in
hardware packs. Slide yoke cover, downrod
accessory, canopy cover, anti-sway adapter and
canopy over downrod. [
Refer to
diagram 3
.
]
(
Note
: Canopy cover must be turned with shiny
side
toward
the motor housing. If using the
anti-sway adapter, it must be turned with flat side
toward
canopy.)
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
hanging ball
stop pin
diagram 2
diagram 1
diagram 3
canopy
motor
housing
yoke cover
canopy
cover
downrod
downrod
electrical wiring
safety cable
yoke set
screw
and nut
clip
downrod
accessory
pin
anti-sway
adapter
