page 9
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test wall control (optional installation) by locating ON/OFF slider
switch on wall control, then set to the ON position. Test ON/OFF
and dimmer function on light kit (L2) and uplight (L1) and then
test fan speeds. Next, locate handheld remote control. Test the
light ON/OFF function by pressing the L2 and then the L1 button.
Test the dimmer function by pressing and holding down the L2
button for 1 second; repeat with the L1 button. Test fan speeds
with the different fan speed buttons. If the wall and/or handheld
remote control operates all of the functions of the fan and light,
battery has been installed correctly. If the wall and/or handheld
remote control do (does) not operate all of the fan/light
functions, refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan to reverse direction.
Use "reverse" button to recirculate air depending on the season.
NOTE
: If the wall control/handheld remote control interferes with
other appliances,
turn off power
and go back to the instructions
in Section 11 above.
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - turns
uplight
ON/OFF when pressed once;
dims
uplight
when pressed and held down
L2
button -
turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
REV
button - used to REVERSE blade direction
(fan must be set on
low
before
reversing blade
direction)
1
1
-
2
2
-
wall control
1
1
-
2
2
-
CAUTION
:
The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the fan
OFF
button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds
and then turn power back on.
Within 60 seconds of restoring the power, press and hold the
OFF
button on
the front of the handheld remote control for 5 seconds (or until light blinks
twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
handheld
remote control
1
1
-
2
2
-
1
1
-
2
2
-
11. Automated Learning Process./Activating Code.
