page 7
9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate (on
underside of motor) and partially loosen the
other 2 screws. Align slotted holes in fitter plate
with loosened screws in motor plate, allowing
molex connections from motor housing to
come through hole in middle of fitter plate.
Twist fitter plate to lock. Re-insert screw that
was just removed and tighten all 3 screws
securely. [
Refer to
diagram 1
.
]
["Light Kit Assembly" continued on next
page.]
8. Blade Assembly.
WARNING
: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and
break.
Time Saver
: Washers for blade attachment
screws can be set on each screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide a blade
through one of the narrow, rectangular
openings on the motor housing, aligning
holes in blade with holes in blade arm,
which is pre-attached to the
underside
of
the motor housing and located
inside
the
motor housing--
refer to drawing at right
.
Insert 3 blade attachment screws (along
with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
NOTE
: Tighten blade attachment screws
twice a year.
fitter plate
motor plate
molex connections
blade
(
view from
underside
)
blade arm
motor housing
blade attachment
screws and washers
diagram 1
