page 10
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch
(if applicable). Test wall control (optional installation) by
locating ON/OFF slider switch on wall control, then set to
the ON position. Test the light ON/OFF and dimmer
function with L1 button and then test fan speeds. Next,
locate handheld remote control. Test the light ON/OFF
function by pressing the L1 button; test the dimmer
function by pressing the L1 button and holding it down for
up to 5 seconds. Test fan speeds with the different fan
speed buttons. If the wall and/or handheld remote control
operates all of the functions of the fan and light, battery
(batteries) has (have) been installed correctly. If the wall
and/or handheld remote control do (does) not operate all of
the fan/light functions, refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan to reverse
direction. Use "reverse" button (
REV
) to recirculate air
depending on the season.
NOTE
: If the wall control/handheld remote control
interfere(s) with other appliances,
turn off power
and go
back to the instructions in Section 11 above.
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(switch not functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
L2
button -
(not applicable for this fan)
REV
button - used to REVERSE blade direction
(fan must be set on
low
before
reversing blade
direction)
1
1
-
2
2
-
wall control
1
1
-
2
2
-
CAUTION
:
The wall and/or handheld remote control can be programmed to
multiple receivers or fans. If this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on
wall control to the ON position. Within 60 seconds of turning on the wall
control, press and hold the fan
OFF
button on the wall control for 5 seconds
(or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds
and then turn power back on.
Within 60 seconds of restoring the power, press and hold the
OFF
button on
the front of the handheld remote control for 5 seconds (or until light blinks
twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 13 below.
handheld
remote control
11. Automated Learning Process./Activating Code.
1
1
-
2
2
-
1
1
-
2
2
-
