page 4
5. Fan Assembly.
Remove hanging ball from downrod provided
by loosening set screw on hanging ball. Remove
pin and clip. Lower hanging ball and remove
stop pin. Then slide hanging ball off of downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nut at top of motor
housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
[
Refer to
diagram 2
.
]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull
extra wire slack from the upper end of the
downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align
with holes in yoke--
make sure wires do not get
twisted
. Re-insert pin and clip previously
removed. Tighten yoke set screws and nut
securely.
[
Refer to
diagram 2
.
]
Slide yoke cover and canopy over downrod.
[
Refer to
diagram 3
.
]
Thread wires through hanging ball; then slide
hanging ball over downrod--the top of the
downrod should be noted as having a set screw
hole; use this hole when setting the set screw.
Insert stop pin into top of downrod and raise
hanging ball. Be sure stop pin aligns with slots
on the inside of the hanging ball. Tighten set
screw securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on
hanging ball) completely could result in the fan
becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
diagram 2
diagram 1
diagram 4
set screw
hanging ball
stop pin
pin
clip
set screw hole
hanging ball
stop pin
diagram 3
yoke set
screw
and nut
clip
downrod
wiring
safety cable
pin
canopy
motor
housing
yoke cover
downrod
