4. Hanging Bracket Installation.
page 3
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7 ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400 square
feet (37.2 square meters).
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing
a longer downrod (0.5 in /1.27 cm diameter).
Other installation, such as
flushmount
, is
not
available for this fan.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
Vaulted ceiling
angle is not to
exceed 20 degrees.
downrod
installation
flushmount
installation
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
blade edge
7 feet
(2.13m)
(76cm)
30
inches
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to the
OFF position.
WARNING
:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING
:
When using an existing outlet box, be sure the
outlet box is securely attached to the building structure and
can support the full weight of the fan. Ensure the outlet box
is clearly marked "Suitable for Fan Support." If not, it must
be replaced with an approved outlet box. Failure to do so
can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and that
a ground wire (
GREEN
or bare) is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box.* If installing on a vaulted
ceiling, face opening of hanging bracket towards high
point of ceiling. Arrange electrical wiring around the
back of the hanging bracket and away from the bracket
opening.
*Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this will
support the fan.
hanging bracket
spring washers
outlet box screws
flat washers
